[Pmason1978]

Hi.
I’ve had the flashing coil, abs and lack of power on and off for a month or so, codes said fuel sensor so that got replaced and was fine last night, this morning it has a flat spot on acceleration and the lights are back and lack of power, any ideas? I’m thinking possibly injectors?

 

[nicam49]

Reading your previous thread

Loss of power

Hi, new to owning a jag but I have a 2006 xtype 2.2 turbo diesel I’ve had the flashing coil and abs light come on and a lack of power. If I pull over and turn the ignition off, wait for a minute then start again the problem goes away, last time it happened it drove fine for nearly a week before...

www.jaguarforum.com

Did you carefully inspect the boost pipes for a split?
You're going to have to read the codes with a JLR reader, no good taking a guess at stuff. Let us know what codes you get... If you only get generic codes, then you're not using the proper reader.
AFAIK there's no such thing as a 'fuel sensor' on your car, so what exactly got replaced and what code(s) led up to the conclusion it needed changing. If you don't know how long the fuel filter has been on the car, then that's always the 1st thing to change.

 

[Pmason1978]

Reading your previous thread

Loss of power

Hi, new to owning a jag but I have a 2006 xtype 2.2 turbo diesel I’ve had the flashing coil and abs light come on and a lack of power. If I pull over and turn the ignition off, wait for a minute then start again the problem goes away, last time it happened it drove fine for nearly a week before...

www.jaguarforum.com

Did you carefully inspect the boost pipes for a split?
You're going to have to read the codes with a JLR reader, no good taking a guess at stuff. Let us know what codes you get... If you only get generic codes, then you're not using the proper reader.
AFAIK there's no such thing as a 'fuel sensor' on your car, so what exactly got replaced and what code(s) led up to the conclusion it needed changing. If you don't know how long the fuel filter has been on the car, then that's always the 1st thing to change.

Thank you, I’m getting c1155 left speed sensor code, would that put it into limp mode?

 

[Pmason1978]

So after investigating the the speed sensor fault, the wire had corroded , replaced the wire and the cars fine, looks like the error code was putting it into limp mode

 

[JimboV8]

So after investigating the the speed sensor fault, the wire had corroded , replaced the wire and the cars fine, looks like the error code was putting it into limp mode

Excellent news and thanks for the update.