Jaguar Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
77 Posts
Discussion Starter · #1 ·
Hello everyone,

I have a 2007 XKR coupe which I'm getting the front wheels refurbished on, so whilst they were off I thought it a good idea to change the air filters.

That's been duly done, but when I pulled back the wheel arch liner on the offside - a polystyrene block fell out before I could see where it came from.
When I checked the nearside - nothing was there.
I've had a bit play about where I think it might go but there's nothing obvious. One photo shows where I might go - just under the hose for the headlight washer.

Any ideas or suggestions very welcome.
Grey Wood Gas Snout Metal

Hand Gesture Finger Nail Bumper

Rectangle Grey Line Wood Font

Automotive tire Motor vehicle Gas Automotive exterior Auto part
 

·
Registered
Joined
·
77 Posts
Discussion Starter · #2 ·
Problem solved - I found this post on another forum which shows where it goes.
I'm hoping I can slide it back into place from inside the liner and not even have to contemplate removing the front bumper

 
1 - 2 of 2 Posts
Top