Jaguar Forum banner

X300 brake survo pipes...

884 Views 1 Reply 2 Participants Last post by  b1mcp
Guys, I've just replaced the brake setup on my xj40 for a vac survo from an x300.... but I need to check which port from the master cylinder feeds the front brakes...... so does anyone know off the top of their head, or could someone take a peek at their car for me, as I dare say getting them around the wrong way could create some interesting stopping!!

Cheers
Jono
1 - 2 of 2 Posts
That's not as easy as it sounds. The master cylinder pipes outlets only go to the ABS unit and the ABS unit feeds the front and rear.

AFAIK the outlet nearest to the servo is the primary circuit (front). However, I don't think there is any balancing or pressure reduction function in the master cylinder. That is taken care of by valves in or on the ABS unit.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top